Autocad LT2008 Multiple lines [draw partitions]

[22oakdene]

Can anyone offer some help on the above.
I would like to draw a partition consisting of 2 lines 75mm apart [representing the distance between the studs] and offset these 2 nr lines 12mm [representing the wallboard]. However I would like to do this quicker than the usual technique of drawing lines individually and offsetting, etc.
If it could draw the metal or timber studs also that would be a bonus !

Hope that makes sense.

Thanks Again

[architech]

I don't think you can do this in LT.... :confused:

You might need to buy the LT-Extender to run LISPs (macros) in order to do this type of routine....