Dimension Question in Lt2000

[gumbay50]

We have our standard drawing setup for dimensions set on decimals. However, some dimensions need to be fractions. If I want a fraction with limits or deviations when I change the primary units to fractions in the Properties the tolerances are still in decimals. I can change the dimension by modifying the dimension style for the whole drawing, but I don't want to do that. Anyone know why the tolerances don't change when the primary units change for a particular dimension? :boohoo:

[architech]

You could always make a new dimstyle with your desired setting.:cartman:

Or you could just editted the dim and go into its properites and change the decimal setting to architectural for fractions.

Hope that helps:drinks: